Hyundai Veloster Crankshaft Position Sensor Location
Hyundai Veloster crank angle sensor location
Hyundai Veloster crankshaft position sensor location: The crankshaft position sensor on a Hyundai Veloster is typically located near the crankshaft pulley at the front of the engine. The exact location can vary slightly depending on the model year and engine type.
Hyundai crankshaft position sensor symptoms
A failing crankshaft position sensor in a Hyundai can cause several noticeable symptoms, including:
- Check Engine Light: The “Check Engine” light will likely illuminate on your dashboard.
- Engine Stalling: The engine might stall unexpectedly, both at idle and while driving.
- Difficulty Starting: You might have trouble starting the vehicle, or it may take longer than usual to start.
- Poor Performance: The engine may run roughly, misfire, or have poor acceleration.
- Irregular Idling: The engine may idle inconsistently or roughly.
- Reduced Fuel Efficiency: The engine might consume more fuel than usual due to improper ignition timing and fuel mixture.
These issues occur because the crankshaft position sensor provides crucial information about the crankshaft’s position and speed to the engine control unit (ECU), which uses this data to control ignition timing and fuel injection. When the sensor fails, it disrupts these processes, leading to the mentioned symptoms.
What is the code PO336 on a Hyundai Veloster?
The P0336 code on a Hyundai Veloster indicates an issue with the Crankshaft Position Sensor “A” Circuit Range/Performance. This means that the engine control module (ECM) has detected that the signal from the crankshaft position sensor is out of range or not performing correctly. This can lead to symptoms such as rough idling, stalling, difficulty starting, and poor engine performance.
