G37 camshaft position sensor
What happens if a camshaft sensor goes bad?
A faulty camshaft position sensor can cause several issues with your vehicle’s performance. G37 camshaft position sensor symptoms:
- Difficulty Starting: The engine may crank but struggle to start, or it might not start at all.
- Engine Stalling: The engine might suddenly stall while idling or at low speeds.
- Rough Idle: The engine may idle roughly, leading to vibrations and shaking.
- Check Engine Light: The check engine light will likely come on, indicating a problem with the sensor.
- Poor Acceleration: You might notice hesitation or a lack of power when you try to accelerate.
- Misfiring: The engine may misfire, causing rough running and loss of power.
- Reduced Fuel Efficiency: The engine might consume more fuel than usual, resulting in poor fuel economy.
- Engine Vibrations: The engine could run roughly or vibrate more than normal.
The camshaft position sensor is essential for the engine’s timing and fuel injection. Its failure can disrupt these processes, leading to these performance issues.
Can I drive with a broken camshaft sensor?
While you might be able to drive with a broken camshaft position sensor, it’s not recommended. Here’s why:
- Engine Performance Issues: You may experience poor acceleration, rough idling, and engine misfires, which can make driving difficult and less safe.
- Stalling: The engine might stall unexpectedly, especially at low speeds or while idling, which can be dangerous in traffic.
- Difficulty Starting: You might find it hard to start the engine, and it could leave you stranded.
- Increased Emissions: A faulty sensor can lead to poor fuel combustion, resulting in higher emissions and possibly failing emissions tests.
- Check Engine Light: The check engine light will be on, indicating an unresolved issue with the engine.
How many camshaft sensors does the G37 have?
The 2010 Infiniti G37 has two camshaft position sensors. These 2010 infiniti g37 camshaft position sensors are located at the front of the engine, one for each bank of cylinders (usually one on the driver’s side and one on the passenger’s side).
Is a camshaft sensor easy to replace?
Replacing a Infiniti G37 camshaft position sensor can range from relatively easy to moderately challenging, depending on the vehicle’s make and model. For many cars, it’s a fairly straightforward job if you have some basic mechanical skills and the right tools. Here’s a general outline:
Steps:
- Disconnect the Battery: Ensure your safety by disconnecting the negative terminal of the battery.
- Locate the Sensor: Find the sensor, which is usually near the front of the engine, close to the timing cover or the cylinder head.
- Remove Components: You might need to remove parts like the air intake ducts or engine covers to access the sensor.
- Unplug the Sensor: Carefully disconnect the electrical connector from the camshaft position sensor.
- Remove the Sensor: Use the appropriate tools to remove the bolts securing the sensor. Then, carefully take out the sensor.
- Install the New Sensor: Position the new sensor in place, secure it with the bolts, and ensure it’s properly aligned.
- Reconnect the Electrical Connector: Plug the electrical connector back into the new sensor.
- Reassemble Components: Reinstall any parts you removed earlier.
- Reconnect the Battery: Reconnect the negative terminal of the battery.
Tools and Materials Needed:
- New camshaft position sensor
- Basic hand tools (wrenches, screwdrivers)
- Socket set
- Ratchet
- Torque wrench
- Safety gloves and goggles
Tips:
- Check for Damage: Inspect the wiring and connectors for any signs of damage. Replace any damaged parts as needed.
- Torque Specifications: Use a torque wrench to tighten the bolts to the manufacturer’s specified torque to avoid overtightening or undertightening.
